Maestro 2

What is the ‘A button’ (device ID) in Maestro for?

Most Apogee products that use the Apogee Maestro 2 control application will include a ‘Device ID’ button that can be found in multiple Maestro tabs under a graphical icon for the connected Apogee device. You will usually see this button as an ‘A’.

Here is an example of what it looks like when you have a Symphony I/O connected:

img-0

 

The purpose of this button is to quickly identify which Apogee device you’re adjusting parameters in Maestro for. When you click on the button, it will light up the front-panel of the corresponding Apogee device so you can see which device you are adjusting parameters in Maestro for. Click the button again and the device will no longer be identified.

Since multiple Apogee devices can be connected and appear in Maestro at the same time, it can sometimes be confusing to know which device you’re adjusting parameters for. Having more than one Duet or Quartet connected to a Mac may not be as common as having multiple Symphony I/Os or Ensembles connected, but the ‘Device ID’ buttons are there for each product, just in case.

 

A typical use-case:

You have 2 Symphony I/Os connected to one Mac and both are showing up in Apogee Maestro. You can go to the ‘Device Settings’ tab in Maestro and change the peripheral prefix of the 2nd Symphony I/O to ‘B’ (or any other letter you want). Now, when you click the ‘B’ button (Device ID) in Maestro, the 2nd Symphony I/O will become identified.  If you click the ‘A’ button, the 1st Symphony I/O will become identified.

 

No sound or lower level on Symphony I/O outputs 1/2- how to set outputs 1/2 for Line Level

If the first 2 analog outputs of Symphony I/O are too low in level or are muted, it is important to keep in mind that the first 2 analog outputs on Symphony I/O will default to -20dB and can be muted or dimmed, as many people use Symphony I/O as their monitor controller.

If you do not wish to use Symphony I/O as a monitor controller and want to set analog outputs 1/2 to Line Level like the rest of the analog outputs, follow the steps below.
There are a couple of ways to set them to line level like the rest of the outputs-

 

Using the front-panel encoders

 

Turn the left encoder knob until you see the speaker icon on the front-panel

Turn the right encoder knob to bring the output level up to 0dB

 
Using the Maestro’s output tab


Launch ‘Apogee Maestro 2’ from your Applications folder

Scroll all the way to the right

You will see 3 software encoder knobs- one for the Main Speaker outs and 2 for headphones

You can turn the Speaker output knob up to 0dB or click on the drop-down menu where it says ‘Stereo Out 1/2’ and select ‘Line’. This will set it for 0dB Line Level and disable monitor control so you don’t accidentally mute the main outs or turn them down.

Once you make this setting, it will be remembered until you change it again.

Apogee Maestro crashes when I launch it

If Apogee Maestro 2 is crashing every time you try to launch it, follow the steps below:

 

 

– Quit Apogee Maestro.

– Go to your Applications folder and locate the ‘Apogee Maestro 2’ icon.

– Click once on the icon and then hold down the Command key and press ‘i’ for ‘Get Info’.

– In the ‘Get Info’ window, check the ‘Open in 32-bit mode’ checkbox.

– Close the Get Info window and relaunch Apogee Maestro.